LF STATIONARY READER
Stand-alone Access control terminal
ID ZK is a read only (RO) terminal, which requires as a stand-alone device no connection to a PC or a controller. It can be programmed to monitor the entrance to a door, a turnstile or a barrier and is working with RO and RW transponders. With an included master card these transponders can be programmed or deleted from the system, individually.
Although the ID ZK is a RO reading unit, it can also read the serial numbers of RW transponders. So it can be integrated into existing RW applications without the need to issue new transponders.
Although the ID ZK has an integrated antenna, optional an external antenna is available. This may be attached to an object from outside and connected to the ID ZK which is installed inside. So for example the controller for a door lock relay would be placed indoors, protected against manipulation or vandalism.
ID ZK is also available as a circuit board without housing.
Dimensions (W x H x D) 113 mm x 83 mm x 24,5 mm
Weight 120 g
Housing Plastic ASA
Protection class IP 54
Operating frequency 125 kHz
Supply voltage 12…24
V / DC
12…15V / AC
Current consumption max. 1,5 W
Read range up to 10 cm*
Indicator two-digit seven segment display
Supported transponders 125 kHz transponders**
Memory 200 transponders
Relay (changeover contact)
load-bearing capacity 24 V / AC; 1,5 A
Operation –25 °C up to 70 °C
Storage –25 °C up to 70 °C
Relative air humidity 5…95 % (non-condensing)
* Depending on transponder type and transponder size
** For example EM 4001, EM 4002, EM 4022, EM 4102, Unique, HITAG 1, HITAG S, Q5, 555x etc.