HF HANDHELD READER
HF Hand-held Blade Reader
ID ISC.PRH200 is a compact, wireless RFID handheld reader (ISO 15693 or ISO 18000-3M3), who is mainly used in libraries. Typical applications in this environment are: Inventory, searching of media, seeking for media, and automatic checking / rewriting of the AFI bytes or EAS bit of all media.
Further applications are laundries, logistical processes as well as document and asset management.
Depending on the type of media and the reading distance, the output power can be switched between two levels (Standard Mode: 1.5 W and Boost Mode: 4 W). Power supply is a Lithium Ion rechargeable battery that allows for operating times up to 16 hours*.
5 multi-colored LED lights and an integrated sounder act as display elements. Thereby all relevant states are visible on both sides of the device.
Communication with a data base or computer is through a WLAN interface on the reader, that supports the most common encryption protocols.
Dimensions (W x H x D) 460 mm x 260 mm x 27 mm
antenna thickness approx. 1.5 mm
Weight (incl. battery pack) approx. 600 g
Housing Plastic ABS/PC
Protection class IP 30
Colors RAL 7046
Operating frequency 13.56 MHz
RF Transmitting power
- Standard Mode 1.5 W
- Boost Mode 4.0 W
Supply voltage Battery pack
Typ. Operation time normal conditions*
- Standard Mode 16 hours
- Boost Mode 8 hours
Button 2 (On/Off antenna; On/Off reader and change between Standard- / Boost Mode)
Signal generator, optical 5 LED (HF-On, special functions,
WLAN, battery, Power-On/Mode)
Signal generator, acoustic 1 Sounder
Interfaces WLAN / Wi-Fi
Wi-Fi Security Protocols WEP / WPA / WPA2
Supported transponders ISO 15693, ISO18000-3M3 (opt.)
Protocol Modes FEIG ISO Host Mode, Buffered
Read Mode, Notification Mode
Operation 0 °C to 40 °C
Storage –25 °C to 55 °C
Relative air humidity 5…80 % (non condensing)
Europe EN 300 330
USA FCC 47 CFR Part 15
Canada RSS-210, Issue 8
EMC EN 301 489
*Typical operation time at normal conditions: In practical application, the antenna should be turned on only if the antenna / reader is near enough to the relevant transponders.
Regarding the ratio „Antenna on/off“, FEIG ELECTRONIC expects a ratio of 50%.
**Charging time: 3.5 – 4 hours